Dầu KLUBER KLUBERalfa HX 83-302

KLUBER KLUBERalfa HX 83-302 Is a long-term grease.

KLUBER KLUBERalfa HX 83-302 is a Long-term lubricating greases for seals, guides and rolling bearings subject to high thermal stress.

Benefits for your application

– Extremely wide service temperature range
– Low friction torques
– Low evaporation rate
– Excellent long-term stability
– Long component life
– in a wide service temperature range
– in contact with aggressive media
– under vacuum and ultra-high vacuum
– where sensitive plastic materials are used
– High component performance
– due to low friction values in sliding contact
– due to low stick-slip tendency
– due to low gasification, no VOC (Volatile Organic Compounds) emission

Description

KLUBERalfa lubricants based on perfluorinated polyether (PFPE) have been developed for specific applications where optimum performance under lifetime lubrication conditions is required. The PFPE base oils contained in KLUBERalfa HX 83-302 have an
exceptionally flat viscosity-temperature curve. With a consistency class of NLGI 2, KLUBERalfa HX 83-302 can be used at temperatures as low as –60°C and even ensures loadbearing lubricating films at temperatures as high as 240°C.

KLUBERalfa HX 83-301 and KLUBERalfa HX 83-302 should be used for all those applications requiring a high kappa value anda very good load-carrying capacity of the lubricant over a wide temperature range.

For special applications KLUBERalfa HX 83-301 is available (NLGI grade 1).

Application

Plastics and seals

KLUBERalfa HX 83-301 and KLUBERalfa HX 83-302 offer exceptionally low friction values along with a good stick-slip behaviour, even in long-term tests. The temperature of friction points subject to dynamic loads can therefore be reduced in many applications, which has a positive effect on the component’s service life.

The service temperature range indicated exceeds most standards specified by e.g. the automotive industry. Depending on the component KLUBERalfa HX 83-302 is applied in small to very small quantities. Application example: O-ring lubrication in pneumatic switches in the automotive components industry.

General behaviour towards plastics and elastomers:

Lubricating greases based on fluorinated polyether oils and PTFE are generally regarded as neutral towards elastomers and plastics (possible exception: perfluorinated rubber). Nevertheless compatibility with the materials should be tested, especially prior to series application.

Rolling and plain bearings

KLUBERalfa HX 83-302 is suitable for special applications subject to very high service temperatures and frequent thermal fluctuations. Its consistency ensures low starting torques even at low temperatures. Application example: Electric motor bearings with a low starting and a high operating temperature.

Clean room technology

Contrary to the general opinion, special lubricants like KLUBERalfa HX 83-301 and KLUBERalfa HX 83-302 do not constitute an additional particle source, but on the contrary often contribute to clearly reducing wear-related particle emission.

Application notes

For optimum lubrication results, we recommend cleaning the friction points with white spirit 180/210 followed by KLUBERalfa XZ 3-1. Then apply clean, dry compressed air or hot air to remove any remaining white spirit residues.

For initial lubrication, the friction points must be clean and bright (i.e. free from oil, grease or perspiration) and free from particles. We will be pleased to give advice on the optimisation of lubricant life.